From Kenny Balys Sent Wed, Jan 3rd 2018, 20:24
No, the trimmers are all oldies. I did totally re-cap mine, all tantalum gone. its stable once i get these kinks worked out. Bob Grieb (Tauntek) told me the Chroma uses the same edge connectors and that they are availble still. I am going to order new ones and replace them. I strongly suspect that my edge connectors are dirty. On 03.01.18 20:17 , xxxx@xxx.xx wrote: > When mine was working I did not have these problems. Did you ever > exchange those trimmers? > > > Am 03.01.18 um 20:30 schrieb Kenny Balys: >> >> This is something I run into often, the Banana has sat for a few weeks >> and then when I go to play, a few voices fail tune or do not respond >> as expected. >> >> Possible Remedy: >> --------------- >> - Press A+H simultaneously to enable voice mute mode: identify the >> troubled voice(s) >> >> - split the Banana open ( he he.... ) >> >> - undo the wooden voice card restraint blocks' frame tops >> >> - pull the voice board out, then put it back in (( possibly squeeze >> chips back into sockets if loose)) >> >> The Banana voice boards seem to walk out of their edge connector >> sockets and/or chips wiggle out of their sockets. Its really irritating. >> >> I have found that its better to keep the wooden restraint caps off >> when playing. Just don't forget to put them back before moving it. >> >> >> ** fix assumes that everything else is otherwise working correctly >> > >