From Florian Anwander Sent Fri, Apr 6th 2018, 08:31
Hello Sam Am 06.04.2018 um 02:28 schrieb Sam Mims: > > Jupiter 4 compatibility: > > The Juno-6/60 solder lugs are in a different configuration, and even > if you could hot-wire it in, you'd need to clip the shaft shorter, and > file it a bit to get the slider knob on there correctly. If it can be > done, it will be a lot of trouble... > > > RS-505 and VP-330: > > This is a better possibility. I don't have either of those here to > eyeball in person, but from the service manuals, it looks like the pin > configuration is basically the same > > Sorry, but at least in the PCB layouts in the service manuals from Sensos site show three different layouts for the sliders of Juno-6, JP-4 and RS-505. The Juno has the housing pins at the end, the slider pins on each end centered between the housings pins and the resistor strip at a side position at 10% and 90% of the length. The JP-4 has the housing pins at 33% and 66% of the length and all electrical pins in one row at the side The RS-505 (same as VP-330) has the housing pins at the end but much wider housings than the Juno, all electrical pins are at 10% and 90% of the length. Florian -- http://www.florian-anwander.de