From DJ Maytag Sent Wed, Jun 27th 2018, 15:31
+1 on Syntaur, but make sure to also get replacement slider caps at the = same time. My original caps don=E2=80=99t stay on the new sliders very = well. I=E2=80=99m sure there=E2=80=99s an easy solution to that though. Anyway, I bought a full set last fall and finally got around to = replacing all of the sliders and pots a few weeks ago. It=E2=80=99s also = a VERY good idea to replace the power inlet and power switch while you = are at it. I think there was another part or two I replaced beyond = Syntaur=E2=80=99s 101 Service Kit. As an improvement, to its sound, Tubbetec recommends adding an extra = ground wire from the D/A chip to the power inlet ground. It adds a TON = of noise, and adding an extra heavy ground wire reduces the noise floor = significantly. > On Jun 27, 2018, at 9:54 AM, A. Horton <xxxxxx.xxxxxx@xxxxx.xxx> = wrote: >=20 > I'm finally getting into servicing my own gear - where's the best > place to pick vintage spare parts like this?