From yahoo Sent Thu, Aug 3rd 2017, 07:20
From yahoo Sent Thu, Aug 3rd 2017, 07:20
I'm sorry - that's not possible. The socket has essentially only two pins
(GND + signal). The additional pins are only switching contacts used for
normalling. For details please refer to the A-100 DIY page on our website:
www.doepfer.com > English > PRODUCTS > A-100 > DIY page
You have to install an additional socket if you want to use the inverted
output. To be on the safe side I'd recommend to connect the signal via a 1k
protection resistor to the socket.
Best wishes
Dieter Doepfer
> Hi Dieter
>
>
> Thanks for the information :) What I am attempting to do is add
> an extra inverted output socket. A socket has four pins, and I
> see these 2 pins, but I'm sure how to connect all the pins of the socket?
>
>
> What I ideally need is someone to tell me "connect this pin on
> the socket to this pin on the board and this to this.....etc" ;)
>
>
> Thanks
> Alan
------------------------------------
------------------------------------
------------------------------------
Yahoo Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Doepfer_a100/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/Doepfer_a100/join
(Yahoo! ID required)
<*> To change settings via email:
xxxxxxx_xxxx-xxxxxx@xxxxxxxxxxx.xxx
xxxxxxx_xxxx-xxxxxxxxxxxx@xxxxxxxxxxx.xxx
<*> To unsubscribe from this group, send an email to:
xxxxxxx_xxxx-xxxxxxxxxxx@xxxxxxxxxxx.xxx
<*> Your use of Yahoo Groups is subject to:
https://info.yahoo.com/legal/us/yahoo/utos/terms/