Re: [AH] Doepfer MAQ

From Nick Zampiello
Sent Tue, Sep 30th 2008, 23:20

Content-Type: text/plain; charset=us-ascii

yes i did.

when i maxed out the internal trim pots i got 4.76 volts.

and the 3 cv outs were not in any way consistent with this.  4.76 was the most out nd it was cv out 1.

i will say that the CV expansion card looks like it was installed by a neanderthal.

the holes were badly drilled.  and there's no labels on the back.

but the previous owner told me that it was installed at the factory so....

I Don't Know!~




New Alliance East has moved to:

New Alliance East
110-120 Brookline St
Cambridge, MA 02139


----- Original Message ----
From: Lyndon Corbett <>
Sent: Tuesday, September 30, 2008 4:57:56 PM
Subject: Re: [AH] Doepfer MAQ

I am assuming you downloaded the manual:

and looked at the last phrase on page 30 and the diagram on page 31?


On Tue, Sep 30, 2008 at 9:49 AM, Robert G Willis <> wrote:

> I got one sent to Australia from USA.
> I had problems with it with voltage, and just assumed that I had to buy
> the quantizer to make it work.
> But I never bought the quantizer.
> R.
> -----Original Message-----
> From: Lyndon Corbett []
> Sent: Monday, 29 September 2008 21:32
> To:
> Subject: Re: [AH] Doepfer MAQ
> >
> >
> > no answer to the initial questions?
> > where is the loop all 3  layers function?
> >
> I couldn't figure this out yet, but would love to know as well. I've
> only
> had mine for a short time and unless someone knows first hand, I won't
> be
> able to mess with it until tomorrow.
> Lyndon